Zega Mame Boy+ GameBoy Zero Raspberry Pi Mod Pre-Soldered Kit

Description: A custom PCB kit designed to fit perfectly inside a GameBoy shell. Runs on a Raspberry Pi Zero or Zero 2 and allows you to play thousands of retro games using Retropie. Uses rechargeable lithium batteries which can be recharged via USB-C. Includes safe shut-down and power-off and offers crisp, clear digital audio. The Zega Mame Boy Plus / Gameboy Zero kit is the newest variation including 4 button support, shoulder buttons support and simple Raspberry Pi installation. Raspberry Pi soldering is no longer required with a Raspberry Pi that has pre-soldered pins. Includes the Mainboard with 2.8 inch LCD, charging / audio board with battery extension cable and audio jack with speaker. Soldering is required to complete the installation. Please ensure you download and read the Pre-install and setup guide from the Zega Mame Boy main page. INCLUDED: 1x Mainboard 1x 2.8" Serial LCD 1x Charger board with integrated lithium charger, battery level and safe shutdown 1x Headphone jack PCB 1x Speaker with cable and connector 1x Mainboard to Charging board ribbon connector 1x Audio jack cable with connectors 1x Battery Extension Cable (*see notes) PAIRS WELL WITH: Zega Mame Boy+ X/Y Button Bracket Zega Mame Boy+ Shoulder Button PCB and Bracket 40 Pin Male Header for the Raspberry Pi (2.54 Inch) 2000 mAh Battery for Zega Mame Gear and Zega Mame Boy DOCUMENTATION: Mame Boy Pre-Install Checks Guide Mame Boy Pre-Install Checks Video Guide Zega Mame Boy+ Support Portal Downloads/STL Files/Images Preparing DMG Shell NOTES: *The battery extension cable needs a battery with 2mm connector. This does not come pre-soldered to allow you to use your own battery set-up if needed. Mame Boy + kits requires a Raspberry Pi with a header. If you have a Pi with a pre-installed header, no soldering required. If not, you will be required to solder the header to the Pi. Although not required, adding the additional 2 front buttons will open up more games to play on the Zega Mame Boy. Some shell modification is required. You can also purchase a ready drilled shell from the Zega store. You can use any DMG shell for install, however, you will need to prepare/modify the shell. Please see documentation. You will need an original sized/non-IPS lens/screen for this kit. PCB color may vary. As of 2/7/24 the PCB is black. Raspberry Pi, shell, buttons, membranes, lens, battery not included. WARNINGS: Please ensure you are confident in your soldering ability to attempt this project. Under no circumstances will any refunds/replacements be made if soldering has been attempted.

Price: 59.99 USD

Location: Willow Grove, Pennsylvania

End Time: 2024-08-03T16:57:09.000Z

Shipping Cost: 4.5 USD